BAND-IT S75099 Pneumatic Junior Clamp Application Tool User Manual
Page 18
Document# P36687 Rev. I
© Copyright
BAND-IT-IDEX, Inc. 2013
All rights reserved
www.BAND-IT-IDEX.com
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street Denver,
CO 80216-3070 USA
P: 1-800-525-0758 F: 1-800-624-3925
18
S75099 Pneumatic
Junior Clamp
Application Tool
Installation Instructions for the J93099 Cutter Blade Kit
Replacement
Service Parts
*Components of this kit are a
dimensionally matched set. You may
have parts that look similar, but they
are
different
dimensionally.
Parts
should be discarded and only new
matched sets should be used.
1.
Remove old Cutter Blade Screws,
Cutter Blade and Backing Plate and
discard.
2.
See illustrations to determine the
correct positions for correct component
assembly.
3.
Hold Cutter Blade and Backing Plate
together, insert screws and tighten.
Installation Tip: This kit contains multiple sets
of screws with varying lengths. Choose the
correct length screw for your application.
Threads should protrude through the Cutter
Blade by less than
¼” .
Operating Tip: Keep the bolts tight. A loose
bolt may cause cracking or premature wear of
the Cutter Blade or Backing Plate. This could
result in improper clamp tensioning, locking
and cutting of excess clamp tail.
Operating Tip: Keep the leading edges of the
Cutter Blade and Backing Plate free of metal
shavings. Metal shavings will result in clamp
material gauging during tensioning. By hand,
DO NOT USE POWER TOOLS, clean and
hone the leading edges. Honing should polish
surfaces, not remove material.