Barranca Diamond 6-inch TS6 Trim Saw - Manual (Page 14)

1
The 6-inch Trim Saw will continue to perform at optimum levels with proper care, daily cleaning, and
general maintenance.
Figure 13: Drain Pipe
CAUTION Place the ON / OFF switch in the OFF position and unplug cord before servicing
and when changing accessories, such as blades and belts.
1. Place a five-gallon bucket or collection container under the pipe outlet cap.
2. Remove the cap with an adjustable wrench to let the lubricant flow into the bucket for
proper disposal.
• It may be necessary to hold the pipe with gripping pliers to prevent it from unthreading
from the reservoir when removing the cap.
• The sludge residue will likely not flow through the drain pipe and will remain inside
the reservoir.
3. The sludge should be removed when the lubricant is drained by removing the belt
guard, saw table and blade, and extracting the sludge with a spatula or spoon.
4. Once the sludge is removed, wipe clean the inside of the tank with a disposable towel
and refill the lubricant to cover the bottom 1/4" (6.35 mm) of the blade. (see Figure 6)
5. Dispose of the used coolant and sludge properly.
6. Be sure to check the level of the lubricant inside of the reservoir after every 3 to 5 hours
of use. The lubricant will be absorbed onto the rock material, combine with rock mud
(sludge) and be lost due to heat and evaporation.
Maintenance
TS6 MAINTENANCE