BASELINE Lift BLM1000 User Manual
Page 3
3
IMPORTANT:
It is the shop owner's responsibility to provide a satisfactory installation area for
the lift. Lifts should only be installed indoors on level concrete floors with a minimum of 4 inches
(102mm) and 3000 psi (20.7MPa) concrete that has been aged a minimum of 30 days. Please
consult a qualified individual if any doubt exists concerning proper installation and subsequent safe
operation of the lift. Do not install the lift on asphalt or outdoors.
Prior to installation, it is the shop owner's responsibility to provide constant electrical power in the
correct voltage, phase, etc., and all wiring for electrical hook-up of the lift. The shop owner must
insure that the electrical installation conforms to local building and safety codes. Where required,
the shop owner will provide an electrical isolation switch located in close proximity to the lift. This
switch will have an emergency stop capability and isolate electrical power from the lift for servicing
requirements.
It is the shop owner's responsibility to train all operators in lift
operation and safety.