BASELINE Lift BLMC1500 User Manual
Page 7
7
ASSEMBLY:
(1) Open the carton. Remove lift.
(2) Connect the hose from the cylinder to the air-hydraulic pump.
(3) Connect the compressed air (Max 100 psi) supply to the air-hydraulic pump.
(4) Press the pedal of the air-hydraulic pump to raise up the lift.
(5) Put on the front wheel vise and then tighten all the bolts and nuts. (Optional)
(6) Put on the side extensions with rods and securing pins. Remember to insert the balance bar. (Optional)
(7) Lower the lift by raising the safety bar and releasing the pump pedal. Then put on all the ramps.
(8) Without any load, lift and lower the lift several times to remove air from cylinder.
OPERATION:
1. Loads must be centered on platform at all times.
2. Loads must be firmly positioned and secured on platform at all times.
3. All moving parts have been lubricated at the factory and should be re-lubricated every (6) months.
4. Pivot shaft set screws should be checked frequently to be sure they are tight. These are located at the top
end of the inside frame assembly.
WARNING:
1. Keep safety bar in position at all times
– except when lowering.
2. Keep hands and tools from under carriage.
3. Do not ride vehicle onto lift.
4. Lift must be in the lowered position when moving.
5. Foot operated AIR-HYDRAULIC pump should be at least 3 feet away from lift during raising and lowering.
6. Lift is recommended for indoor use only.