Beka Preschool easel - Manual

Manufactured by Beka, Inc. • 542 Selby Avenue • St. Paul, Minnesota 55102 • USA
1-888-999-2352 • www.bekainc.com • 651-222-3965 fax
Contents:
Double-sided Easel Support Tray
4 brass screws
4 plastic tray locks
You will need a Phillips screwdriver.
Read instructions completely before beginning.
Step 1:
Use enclosed screws to attach plastic tray locks to bot-
tom of easel storage tray. Use holes drilled next to each
notch in tray’s bottom.
Step 2:
Stand easel upright, legs open for stability. Position
storage tray above dowels connecting easel legs with
notch openings down. Align notches with dowels and
press securely. Pivot tray locks over dowels, holding
tray in place and locking easel open for use.
To Move Easel:
Grasp legs and lift. Do not use storage tray to lift.
To Store Easel:
Pivot tray locks on one dowel, leaving the others in
place. Lift tray off dowel and pivot tray down in line
with easel legs.
Wipe-Off Marker Board Surface
Choose a dry erase wipe-off marker for your Beka easel.
Be sure to test your markers on a corner of the board to
unsure easy erasure before allowing general use. Clean
whiteboard well before use with a soft cloth. Clean
whiteboard regularly. Marker left on the easel for sev-
eral days can be difficult to remove and may stain the
surface.
Chalk Surface
Our green chalk surface is ready to use and is compatible
with any standard chalkboard chalk. If you are unsure of
your chalk, test it on a corner of the board first to insure
easy erasure. Use a soft cloth or chalkboard eraser.
Preschool Easel
Assembly Instructions
WARNING—ADULT ASSEMBLY REQUIRED!
Enclosed hardware includes sharp points and small parts, so
may present hazards to children prior to assembly.
After assembly, an adult should check hardware
periodically to insure it is tight
Dispose of plastic bags and any extra hardware to avoid
potential choking hazards.