Beka Train & activity table - Manual (Page 2)

Step 3
Step 3:
Attach a side:
Position a side on the inside edge of two of the legs.
The dowel holes across the lower edge of the side
should face in (toward the center of the table) and be
off center toward the bottom, or floor. Use 4 screws to
secure the side, passing each screw through a hole in a
leg and then into the side (see photo).
Step 4:
Position dowels:
Slide one end of each dowel into a hole provided for it
in the side. Rest the dowel across the center support
bar. (Train Tables have 5 dowels; the smaller Activity
Table has 3 dowels.)
Step 5:
Attach remaining side:
Hold the remaining side piece so the dowel holes face
in (toward the center of the table) and are oriented to
be off center toward the floor (the bottom edge of the
side; mirror the opposite side piece). Hold the side
just above the legs and carefully fit each dowel into
the hole provided for it. Slide the side into place on
the inside of the legs. Use 4 screws to secure this last
piece, as done in step 3.
Manufactured by Beka, Inc. • 542 Selby Avenue • St. Paul, Minnesota 55102 • USA
1-888-999-2352 • www.bekainc.com • 651-222-3965 fax
Step 4
Step 5
Assembled Train Table
Step 6:
Install a table top by carefully lowering it
into the space above the table’s dowels.
Beka’s two piece top, as well as tops from
other manufacturers may be used. Table
tops must fit snuggly in place. Do not use
a top if it leaves more than 1/8” of space
between the top and the pieces framing it,
as doing so can create a pinch hazard!
Appropriate tops provide a secure play
surface for trains and other toys, and will
remain in place during use.
Assembled Activity Table