BELLA 14113 Linea Collection Sport Rocket Blender - Manual (Page 7)

5
Before First Use
1. Carefully unpack the Sport Rocket Blender and remove all packaging materials. Check the contents
to ensure that all parts and accessories are present, and have been received in good condition.
2. Handle the blending blade attachment by its collar only.
WARNING: Do not touch blades. Blades are very sharp. Use extreme care when handling.
Failure to do so can result in personal injury.
3. Wash travel lid in warm, soapy water. Rinse and dry thoroughly.
4. Clean tumbler before use. Fill tumbler one-quarter full with clean, warm water. Following the steps
outlined in the Operating Instructions, pulse several times using the blending blade. Rinse thoroughly.
5. The motor base may be wiped with a damp cloth.
WARNING: DO NOT IMMERSE THE MOTOR BASE IN WATER.
Operating Instructions
1. Place the motor base on a flat, clean, dry countertop or table.
2. Make sure the unit is unplugged.
3. The Sport Rocket Blender comes with 1 blending tumbler.
Place the food to be processed into tumbler.
4. To assemble for blending using the blade’s collar to handle,
place the blade assembly into the blending tumbler.
IMPORTANT: Check to make sure the travel lid is not attached
to the blending tumbler before assembling the blade.
If it is, simply remove it.
IMPORTANT: In the base of the blade’s collar, there is a plastic
gasket seal that creates an airtight fit with the Sport Rocket
blending tumbler. After dishwashing and before each use, always
check to make sure the gasket is properly in place, as the heat
from some dishwashers may cause the gasket to become loose.
WARNING: Never operate the Sport Rocket Blender when the
blending tumbler is empty.
WARNING: Never overfill the processing tumbler.
Do not exceed the MAX line.
5. Hold the tumbler firmly in one hand. Use the other hand to tighten
the up/blade assembly by turning the blade collar clockwise
until snug.
6. Plug the power cord into a 120 V AC electrical outlet.
7. Invert the processing tumbler/blade assembly. Insert the blade collar into the motor base, fitting the tabs
into the slots on the motor base.
NOTE: The Sport Rocket Blender will not operate unless the 2 locking tabs on the motor base are properly
fitted into the 2 slots on the blade collar.
8. To process, turn the processing tumbler clockwise into the motor base and press the front panel
on the base to turn ON and then press again to turn OFF.
WARNING: Do not operate the motor continuously for more than 1 minute at a time.
Allow the motor to rest for 3 minutes before continuing.
9. When processing is completed, press the front panel to turn off, turn the tumbler counter-clockwise in the
base and lift to remove the tumbler/blade assembly.
10. Invert the tumbler/blade assembly. Hold the tumbler firmly in one hand. Use the other hand to turn the
blade collar counter-clockwise and remove the blade from the processing tumbler.
11. Add the travel lid to enjoy fresh juice, blended drinks or smoothies immediately.
Twist the lid to fasten it into the tumbler.
12. Unplug the Sport Rocket Blender when not in use and before cleaning.
Figure 2
Note: keep illustration
callouts aligned
SO-311061_Bella LineaSport Rocket IM_r2.indd 5 2013-10-31 4:33 PM