BELLA 14081 Toast and Brew Breakfast Station - Manual (Page 10)

8
User Maintenance Instructions
This appliance requires little maintenance and contains no user-serviceable parts. Any servicing requiring
disassembly other than cleaning must be performed by a qualified appliance repair technician.
Cleaning and Maintenance Instructions
1. Always make sure the unit is unplugged before attempting to clean.
2. To clean the toaster: Pull out the crumb tray from the side of the toaster and empty it. If toaster is used
frequently, accumulated bread crumbs should be removed at least once a week. Make sure the crumb tray
is re-inserted correctly to the toaster and completely closed before using the toaster again.
To clean the coffee maker: Remove the permanent coffee filter and filter basket, discard used coffee
grounds, loose tea or pods and rinse both pieces thoroughly after every use.
WARNING: To avoid breakage, handle mug with care. Mug will break as a result of impact. Use care when
filling with water to avoid hitting faucet. Do not heat empty.
3. Wipe the exterior with a soft dry cloth to remove dust and superficial stains after toaster cools down.
Never use metal polish. For stubborn stains, use a nylon or plastic pad with a non-abrasive cleanser. Do
not use metal scouring pads or abrasive cleansers.
4. Dry and replace disassembled parts. Make sure the removable filter holder drops down and is properly
seated into the housing.
5. Close the lid.
6. Never immerse unit in water or any other liquid.
7. The power cord may be wound under the bottom of the unit when not in use or for storage.
Descaling the Coffee Maker
It is recommended to perform a special cleaning of your Coffee Maker at least once a month, depending on
frequency of use and quality of water used in the unit. If water in your area is especially hard, the following
cleaning procedure should be performed more regularly. Excessive accumulation of mineral deposits from hard
water can detract from the flavor of the coffee and possibly lengthen brew time. Excessive steaming or prolonged
brew time are signs that cleaning is needed.
1. Fill half the mug with 1 part white vinegar to 3 parts cold water. Pour water and vinegar solution into the
water tank
2. Center an empty mug under the nozzle.
3. Press switch to ON to start brew cycle, allowing all of the solution to drip into the mug. NOTE: During
cleaning, more steam will occur than during normal coffee brewing.
4. When liquid stops dripping from filter holder into the mug, make sure Coffee Maker is powered OFF,
remove the mug and allow liquid to cool for 15 minutes. When cooled, repeat steps 1-4 a second time.
5. Allow Coffee Maker to cool for 15 minutes, rinse by brewing a full mug of cold water. Insert the clean
permanent coffee filter into the removable filter basket before brewing. This step may need to be repeated
in order to remove any remaining vinegar taste.
6. At end of brew cycle, the unit will switch OFF; discard the water in
the mug. Wash the mug, permanent coffee filter and removable filter holder in warm, soapy water and dry
the parts thoroughly.
7. When the Coffee Maker has cooled, wipe the exterior with a dry cloth.
Storing Instructions
1. Unplug unit and allow it to cool completely.
2. Store Toast & Brew in its box or in a cool, dry place.
3. Never store unit while it is still wet, hot or still plugged in.
4. Never wrap cord tightly around the appliance
5. Do not put any stress on the cord where it enters the unit, as it could cause the cord to fray.
SO-310702 Bella Toast & Brew IM_R8.indd 8 2013-11-12 2:33 PM