BKI LGF-FC Gas Pressure Fryer - Manual (Page 40)

Gas Pressure Fryer Maintenance
38
Troubleshooting
Refer to the table below for troubleshooting information.
Problem Cause Possible Solution
Pressure Loss or Not Releasing
Pressure Dead Weight Valve Leaking Clean the weight and orifice. If problems
persist, contact an authorized BKI service
agent for corrective action.
Lid Gasket Leaking Contact an authorized BKI service agent
for corrective action.
Solenoid Valve Leaking or
Stuck After a period of time, it is possible that
the valve seat and/or plunger may stick or
wear. Activate the valve by starting a cook
cycle. You should hear a solid metallic
CLICK sound from the solenoid valve. If
you should hear no sound (or a slow
BUZZING CLICK), contact an authorized
BKI service agent for corrective action.
Safety Valve not seating Contact an authorized BKI service agent
for corrective action.
Shortening Heating Too Slowly Gas pressure is low or isn’t
adjusted properly Contact an authorized BKI service agent
for corrective action.
Bad thermostat or loose
wires Contact an authorized BKI service agent
for corrective action.
Filter System Not Working Uncertain Press the reset button on end of pump
and hi-limit reset button under control
panel. If problems persist, contact an
authorized BKI service agent for
corrective action.
Connections not tight Tighten the connections. If problems
persist, contact an authorized BKI service
agent for corrective action.
Filter valve not open Contact an authorized BKI service agent
for corrective action.
Filter paper on screen
clogged with crumbs Change filter paper. If problems persist,
contact an authorized BKI service agent
for corrective action.
Motor hums, but does not
pump Check for clogged pump. If problems
persist, contact an authorized BKI service
agent for corrective action.
Motor and pump coupling
worn Contact an authorized BKI service agent
for corrective action.
No power to control panel Make sure drain valve is completely
closed. If problems persist, contact an
authorized BKI service agent for
corrective action.
Computer Hangs Computer malfunction. Press and hold the Toggle/Clear button
while moving the FRY/OFF/FILTER
switch from FRY to OFF and back to
FRY. If problems persist, contact an
authorized BKI service agent for
corrective action.