BKI FKM-FC Electric Pressure Fryer User Manual

Page 32

Advertising
background image

Electric Pressure Fryer

Maintenance

 Add new shortening if the fill mark has not been reached.

To refill the pot through the rinse hose, use the steps below:

 Make certain that the rinse hose is connected to rinse hose connector.

 Holding the hose by the handle, place hose nozzle inside the pot.

Hot shortening may splash out of the pot causing severe injury when filling the
pot if the lid is not held down over the hose nozzle. To prevent shortening
splashes, hold the lid down over the hose nozzle.

 Hold the lid down over the hose nozzle to prevent shortening splashes.

 Position the FILL lever in the THRU HOSE position.

 Position

the

FILTER/OFF/FRY switch to FILTER and shortening will automatically pump

into the pot.

 After 1 minute, hold the hose by the handle and carefully raise the lid to check the level of

the shortening.

 Let the filter continue to pump the shortening until the fill mark in the fryer pot is reached

or until air starts bubbling through the shortening.

 As soon as air is seen in the shortening, position the FILTER/OFF/FRY switch to OFF to

prevent shortening degradation.

 Add new shortening if the fill mark has not been reached.

FKM

1. Set

the

FILTER/OFF/FRY switch to OFF.

2. Remove the fryer basket.

3. Make certain that the FKF filter unit or portable filter unit filter pad is clean and not torn.

4. Position the FKF filter unit or portable filter unit under the main drain valve and make sure it’s

filter screen is in place.

5. Ensure that the FKF filter unit or portable filter unit is powered.

6. Move the DRAIN handle slowly to the OPEN position until the shortening starts to flow

evenly. This will prevent excessive splashing of hot shortening.

7. When the pot is empty, place the DRAIN handle in the CLOSED position.

To refill the pot through the drain valve, use the steps below:

 Make certain that the braided hose (located on the drain valve) is connected to it’s mating

part on the FKF filter unit or portable filter unit.

Hot shortening may splash out of the pot causing severe injury when filling the
pot if the lid is not closed. To prevent shortening splashes, close the lid before
filling.

30

Advertising
This manual is related to the following products: