BKI DMXD-S Racer Merchandiser - Manual (Page 11)

11
5. MAINTENANCE
GENERAL
The APW/Wyott Racer Merchandisers are designed for maximum durability and performance, with
minimum maintenance.
CLEANING
DISPLAY LIGHT BULB REPLACEMENT
To preserve the bright finish of the Racer Merchandiser, it is recommended that the exterior and
interior surfaces be wiped daily with a damp cloth. Stubborn stains may be removed with a good non-
abrasive cleanser. Hard to reach areas should be cleaned with a small brush and mild soap.
Clean the glass sides using a common glass cleaner.
The display light is an incandescent light bulb which illuminates the warming area. The bulb has a
special coating to guard against injury and food contamination in the event of breakage.
1. To replace the light bulb, disconnect the power supply and wait until the unit has cooled.
2. Bulbs have a threaded base. Unscrew the light bulb from the unit and replace it with a new
specially coated incandescent bulb.
NOTE: APW Wyott shatter-resistant light bulbs meet N.S.F. Standards for food holding and display areas.
! !
WARNING: To avoid any injury, turn the power switch off at the fuse disconnect switch/circuit
breaker or unplug the unit from the power source and allow to cool completely before performing
any maintenance or cleaning.
! !
WARNING: Only bulbs which meet or exceed N.S.F. Standards, specifically designed for food
holding areas must be used. Breakage of bulbs not specially coated could result in personal injury
and/or food contamination.
! !
WARNING: If service is required on this unit, contact your authorized APW Wyott Service Agent, or
contact the APW Wyott Service Department directly at (214) 421-7366 or (800) 527-2100; fax (214)
565-0976.
! !
WARNING: This product has no “user” serviceable parts. To avoid damage to the unit or injury to
personnel, use only Authorized APW Wyott Service Agents and genuine APW Wyott Parts when
service is required..
! !
WARNING: Genuine APW Wyott Replacement Parts are specified to operate safely in the
environments in which they are used. Some aftermarket or generic replacement parts do not have
the characteristics that will allow them to operate safely in APW Wyott equipment. It is essential to
use APW Wyott Replacement Parts when repairing APW Wyott equipment. Failure to use APW
Wyott Replacement Parts may subject operators of the equipment to hazardous electrical voltage,
resulting in electrical shock or burn.
! !
CAUTION: Use only non-abrasive cleaners. Abrasive cleaners could scratch the finish of your unit,
marring it’s appearance and making it susceptible to dirt accumulation. Do Not use steel wool, other
abrasive cleaners or cleaners/sanitizers containing chlorine, iodine, ammonia or bromine
chemicals as these will deteriorate the stainless steel and glass material and shorten the life of the
unit.
! WARNING: To avoid electrical shock or personal injury, do not steam clean or use excessive water
on the unit.
!
! WARNING: Unit is not waterproof. DO NOT submerge in water. Do not operate if it has been
submerged in water. Do not clean the unit with a water jet.
!
! WARNING: To avoid electrical shock, always unplug the unit before performing cleaning or
maintenance.
!
! CAUTION: Do not use a water jet (pressure sprayer) to clean the unit, or component failure could
result.
!
6. ACCESSORIES
STAINLESS STEEL DIVIDER RODS
Additional stainless steel divider rods help to keep product separate in the channels.