BLACKHAWK! AXIOM U/L RIFLE STOCK CAMO FINISH - Manual (Page 3)

www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
Installation Instructions Continued
Page 4
6. Reinstall trigger guard and hinged magazine floor plate assembly. (Fig. 6) Note: It is crucial that
the trigger guard and hinged magazine floor plate assembly is properly seated in the stock prior to
final installation and torquing of bolts.
7. While holding the trigger guard and hinged magazine floor plate assembly in position, reinstall
the two stock bolts removed in Step 1. (Fig. 7) Note: Take extra precaution not to cross thread bolts.
For best performance, utilize a torque wrench and tighten bolts to a recommended torque of 65
inch lbs. Floor plate should open and close easily.
Fig. 6
Fig. 7
www.BLACKHAWK.com
BLACKHAWK! ® NORFOLK, VA U.S.A. 1.800.694.5263
Installation Instructions Continued
Page 5
8. Reinstall action bolt into receiver. (See owners manual for directions)
9. Reattach pistol group portion of stock to forend. Carefully align square protrusion on front of
stock with corresponding square pocket on rear of forend. (Fig. 8) Utilize provided 1/4” ball end
allen wrench to thread stock bolt into forend. (Fig. 9) Note: Take extra precaution not to cross
thread bolt. If bolt feels tight or rough while tightening, stop, unthread bolt and start over. Tighten
stock firmly until flush.
10. Reinstall rear stock removed in Step 2. Pull down on lever and slide onto pistol grip portion of
stock.
11. Installation of Axiom Rifle Stock is now complete (Fig. 10). Prior to using rifle, verify correct in-
stallation of stock by checking function of action bolt, safety, magazine follower and floor plate.
Fig. 8 Fig. 9
Fig. 10