BLACKHAWK! BREACHERSGRIP SHOTGUN STOCK User Manual
Page 3
www.BLACKHAWK.com
BLACKHAWK!
®
NORFOLK, VA U.S.A. 1.800.694.5263
Page 2
2. Attach the BreachersGrip to the shotgun by aligning the pistol grip with
the rear of the shotgun receiver. (Refer to Fig. 2) Using the appropriate
Hex wrench, tighten the pre-installed Hex head bolt firmly to complete the
installation.
B
Be
e c
ca
arre
effu
ull n
no
ott tto
o ssttrriip
p o
orr c
crro
ossss tth
hrre
ea
ad
d tth
he
e m
mo
ou
un
nttiin
ng
g b
bo
olltt o
orr
rre
ec
ce
eiivve
err n
nu
utt..
NOTE: For Mossberg SpecOps only, remove rubber o-ring from stock bolt.
Remove o-ring by inserting ball end allen wrench into hole located on the
bottom of the SpecOps Stock. Turn wrench counter clockwise while
applying pressure to the bolt with finger. Turn wrench until rubber o-ring is
removed.
NOTE: For all stocks, the rubber o-ring is for packaging use only. If a loose
o-ring is found in the stock packaging, disregard and dispose of it.
NOTE: If the stock is loose or if there is a significant gap between the stock
and receiver after completely tightening the bolt, then two issues may exist.
Issue 1; the bolt has been cross threaded into the receiver nut. Issue 2; there
is debris (powder residue or old thread locking compound) in the receiver
nut that is not allowing the stock bolt to fully engage with all the receiver nut
threads. To clean receiver nut threads, take a small diameter barrel brush
(Approx 1/4” dia.) and insert repeatedly into receiver nut until excess
material has been removed. Re-install stock.
NOTE: For Winchester BreachersGrip, there should not be a gap between stock
and shotgun after installation. Continue to tighten bolt until gap is closed.
Fig. 2