BLITZ Power Meter i-D User Manual

Online manual not for resale purposes

Advertising

INSTALLATION AND OPERATING INSTRUCTIONS

FUNCTION MENU:
- POWER DIGITAL DISPLAY

- SPEED DIGITAL DISPLAY
- POWER/SPEED DIGITAL DISPLAY
- GRAPHICAL POWER DISPLAY
- GRAPHICAL SPEED DISPLAY
- CHASSIS DYNAMO
- DASH MODE
- LAST RECORD

- WARNING

Page 1

INSTALLATION INSTRUCTIONS:

Connect the RED wire to an ignition 12v supply and find a suitable ground for the BLACK wire. The ORANGE
wire needs to be connected to the ECU speed output. To locate the correct ECU pin, refer to ECU booklet.
Using your vehicles chassis and engine code to locate the correct ECU map, attach the orange wire using
the provided wire tap to the ECU speed output wire.

IMPORTANT - When installing, ensure that the orange wire is connected to the ECU speed output before the
speed de-limiter or speed converter (if fitted). If it is connected after this, it may cause incorrect operation of
the unit.

CALIBRATION:
* When the Power Meter is turn on for the first time, you will be in the WEIGHT. PW LOSS mode. This mode
calibrates the Power Meter. NOTE: Weight of the vehicle will be in kg, to set weight in lbs, press MENU button
and scroll down to SPD UNIT, press ENTER and scroll up to MPH and press ENTER to set. Next go back to MENU
and scroll down to POW UNIT and set power in HP, PS, and kW.

SET UP AND CALIBRATION - After the speed and power unit has been set, scroll back to WEIGHT. PW LOSS &
press ENTER. Once in this mode you can set the weight of the vehicle, if it is 2WD/4WD, and set the power loss.
To set, press ENTER button and use the up/down button to set weight, 2WD/4WD, and power loss. Weight of the
vehicle can be found in the vehicle owner manual, make sure you take into consideration your own weight, any
passengers you may have and fuel in the tank. NOTE: weight effects the accuracy of Power Meter. Set if car is
2WD/4WD and also set the Power Loss, see back of manual to see Power Loss of each type of vehicle.

SPEED CALIBRATION - Scroll to SPEED CALIB and press ENTER. To calibrate the Power Meter, you will need
to drive with the Power Meter in calibration mode at a steady 25mph and press ENTER.

Page 1

Online Manual Not For Resale Purposes

Advertising

Popular Brands

Popular manuals