Beko DWD857 - Manual (Page 8)

Make sure your plumbing is suitable to
install your new dishwasher. If in doubt
contact a qualified plumber.
The appliance must be connected to the
water mains using the new hose set
supplied with your new dishwasher. Old
hose sets must not be re-used.
The water pressure coming from the water
mains supply must be a minimum of 0.3 and a
maximum of 10 bars.
Fit the drainage hose of your machine
to the drainage pipe without bending.
Secure your hose firmly to the waste
pipe to avoid it coming off during the
washing process.
The waste pipe must only be connected
into the foul drains and not surface water
drainage system.
The hose should be placed between
50 cm and 110 cm from the floor level
and must not be extended otherwise the
machine may not empty the waste water.
Connect the straight end to your water
mains supply Ensure plastic filter and
black rubber seal is in place.
Please turn on the tap and check for
leakages after connecting the hose.
Please ensure the tap is turned off when
the machine is not used;
If you only have one cold water feed (For
example for your washing machine) don’t
worry. a Y adaptor will provide you with
the additional cold water feed you need
for your dishwasher. Y adaptor is available
from most DIY stores.
1
8
max 1
10 cm
01
0
20
30
40
50
60
70
80
90
100
11
0
12cm
min 4cm
max 110 cm
min 50 cm
18
21
1