Bravox Linha UXP - Manual (Page 5)

-5- UXP10D - UXP12D
ENCLOSURE CONSTRUCTION
The dimensions shown in the tables are intended as a guideline and specific dimensions (HxWxD) may be changed provided
the internal volume of the enclosure is maintained. For best performance the walls of the enclosure should be rigid and not
vibrate as a result of the internal pressures generated by the loudspeakers. BRAVOX recommends constructing enclosures
from medium-density fiberboard (MDF) with a minimum thickness of 3/4". In larger enclosures over 1 cubic foot, internal
bracing that joins opposite walls can be incorporated and the final enclosure should be as rigid as possible. All joints should be
glued and fastened with screws. Additionally, internal joints can be covered with a small bead of silicone adhesive to ensure
that the enclosure is completely air-tight. Drivers should be fastened to the enclosure with self-threading screws with adequate
length and diameter, utilizing all the mounting holes in the frame. To avoid air leakage, a foam rubber gasket or similar sealing
method should be applied between the loudspeaker and the enclosure. The external surface of the enclosure may be painted or
fabric-covered, to suit the consumer.
Since low frequency sounds are not directional, subwoofer enclosures can generally be placed anywhere within the car,
without compromising stereo imaging. While the trunk is the most obvious location, locating them behind the seats is another
possibility. However, different placement locations of subwoofer enclosures can sometimes influence the overall quality of
bass/midbass response. As interior acoustics are different for each vehicle, you may wish to experiment with various mounting
locations before permanently mounting the woofer.
WIRING.
ULTIMATE PERFORMANCE PLUS SUBWOOFERS are offered in Dual Voice Coil configuration in two versions, 2+2
and 4+4 ohms. This allows the user to create virtually any impedance load to match his amplifier.
LIMITED WARRANTY
BRAVOX S/A warrants this product to be free of defects in material and workmanship for a period of one (1) year from the
date of original purchase.
This warranty is not transferable and applies only to the original retail purchaser of the product from an authorized BRAVOX
dealer. Should service be necessary under this warranty for any reason due to manufacturing defect or malfunction, BRAVOX
will, at its sole option, repair or replace the defective product with new or remanufactured product at no charge.
This warranty is void and inapplicable if BRAVOX deems that product has been used or handled other than in accordance with
instructions provided by manufacturer, including but not limited to damage caused by accident, mishandling, improper
installation, abuse, negligence, or normal wear and tear, or any defect caused by repair to the product by anyone other than
BRAVOX or an authorized BRAVOX dealer.
REPAIR OR REPLACEMENT UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE
CONSUMER/PURCHASER. BRAVOX SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL OR
CONSEQUENTIAL DAMAGES, EXCEPT TO THE EXTENT PROVIDED (OR PROHIBITED) BY APPLICABLE
LAW.
THERE ARE NO OTHER WARRANTIES, INCLUDING WITHOUT LIMITATION, EITHER EXPRESS OR
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, WITH
RESPECT TO THE PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
CAUTION
Prolonged exposure to sound pressure levels in excess of 100 dB can cause permanent hearing loss. This high-performance
speaker can exceed this level. Please listen using common sense and restraint, in order to preserve your ability to enjoy its
fidelity.
(Parallel) (Parallel) (Series) (Series)
1 2 4 8