C.B.S. Scientific DCX-800 - Manual (Page 9)

9 www.cbsscientific.com
4
5. Slide pre-cast gel cassette or plate set(s) into
the core assembly with the notched plate
facing in towards the upper buffer reservoir
as shown in figure 4. If using a pre-cast gel
stored at 4°C, allow to warm to room tem-
perature. If pouring your own gels please see
Alternate Protocol (Section 4) on pages 12-
14 describing gel casting using Gel Wrap™.
6. If running one gel, slide white plastic adaptor
plate into the side without the gel. If running
a Lonza 10cm x 9cm gel casssette place
clear shim as shown in figure 5.
7. Close doors and relatch by pressing down
on the white latches so that the assembly
looks like that shown in figure 6.
5
6