CalDigit S2VR Duo Manual - Manual (Page 10)

9
Installing the Hard Drive Tray Modules
Note: Your S2VR Duo is shipped with the drive modules packaged separately to prevent them from damage.
1. Slide tray drives into enclosure, lift lever, tighten the thumbscrew
2. After drives have been installed, check all levers & make sure thumbscrews are locked down.
3. Repeat with all other drives.
Connecting the S2VR to the HBA Controller
The S2VR Duo RAID contains 2 configurable hard drives. After installing the host adapter card and drivers,
connect the S2VR to your computer via your eSATA cable.
1. Attach the S2VR Duo RAID to the installed host adapter controller with the provided eSATA cable.
2. Plug the S2VR Duo into an AC power outlet & turn the power switch of the S2VR Duo to ON, (back of unit)
wait approximately 20 seconds & then move on to Power S2VR Duo ON/OFF for the next steps.
Power S2VR Duo ON/OFF
The power switch for the S2VR Duo is located on the rear panel of the unit. Turn off the S2VR Duo by pressing
the Switch to ON (O) position, to turn the unit off, press the ( | ) position.
Turn on the S2VR Duo first, and then wait 20 seconds and then power up your computer.
Please be careful around the power supply. Accidental contact with internal parts while
the power supply is powered on could lead to electrical shock
.
Open S2VR Manager
The S2VR Duo Manager limits configuration access with a password prompt. The password information is stored
locally on the server running the daemon. The default password is
admin.