Carbolite 2116 used as an indicator - Manual (Page 2)

2132/2116 Indicator
2
MC06 – 1.03
Description
The model 2132 or 2116 controller/indicator is made by Eurotherm, and is fitted by Carbolite
configured for immediate use as an indicator. It is configured for the input (thermocouple) type
for which it was ordered.
The indicator does not contain a real-time calendar, and is not subject to century-end date
problems.
When the indicator is supplied fitted into a furnace or oven then it is usually on whenever the
Instrument Switch is on. When it is supplied in a separate box, then it is on whenever the box is
connected to the electrical supply.
The indicator will only show the correct temperature if it is also connected to type of
thermocouple for which it is configured.
1 O PERATION
No operator action is normally required.
When switched on, the indicator lights up, goes through a short test routine, and then displays the
measured temperature.
The output light and timer light are not used.
The Page key , the Scroll key , and the Down  and Up  keys allow access to parameters
within the controller. Most lists and parameters are hidden and cannot be accessed by the
operator because they contain factory-set parameters which should not be changed. Only the
calibration parameters are normally accessible.
2116 is larger –
see front cover