Carter-Hoffmann MZ243S-2T User Manual

Page 8

Advertising
background image

NORMAL OPERATION

NOTE:

Timer can be

cancelled at any time during
the cycle by
pressing and holding the

TIME KEY for 2
seconds. Digital readout will
display currently selected
timer (e.g “P 1”).

NOTE:

Program timer defaults to “P1” each time the unit is turned OFF

then back ON.

NOTE:

Timer can not be

started until the cabinet is
pre-heated.

DIGITAL READOUT

INCREASE KEY

DECREASE KEY

TEMPERATURE KEY

TIME KEY

NOTE:

Press and release

the TEMP key to view
of verify a cavity
setpoint. Cavity setpoint will
be displayed briefly. If the
cavity setpoint needs to be
changed, refer to Program-
ming Instructions

on page 9-

10.


1. Press the POWER SWITCH, located at the top front panel, to ON. Illu-

minated portion of switch will glow, indicating power is ON. Pre-heat
cabinet for 20 minutes. When first turned on, digital readout will display
“LO” until the cabinet reaches 122°F (50°C). After the cabinet reaches
122°F (50°C), the digital readout will display the current temperature,
until the temperature reaches the setpoint. Once the cabinet reaches
setpoint, the digital readout will display “P 1”. This indicates the cabinet
is ready to hold product.






Select the desired timer program by pressing the UP / DOWN ARROW
KEYS. Each controller has six programmable timers (“P 1”, “P 2”, “P 3”,

“P 4”, “P 5” and “P 6”) for each group of cavities. Different program times

can be used for different parts of the day (breakfast, lunch, dinner) or for

alternate

products.








2. After pre-heat, the digital readout will display the current selected timer

(e.g. “P 1”), indicating that the cabinet is ready to hold product.

3. Load cooked product into pans and place pans on shelves.

4. Press TIME

key to start the timer. Refer to Programming

Instructions

(page 10) to change programmed time.

Cavity temperature setpoint
range is between 122°F and
225°F (50°C and 107°C)


NOTE:

Press and release the appropriate TEMP KEY

to view or

verify setpoint. Setpoint will display briefly. If temperature setpoint
needs to be changed, refer to Programming Instructions, page 9.

NOTE:

To select other timer programs (“P 2” - “P 6”),



press the INCREASE KEY

or DECREASE KEY

until the

digital readout displays the desired program.

Typical
temperature

reading

Cabinet is
READY

Temperature
is LOW

5. The digital readout will count down, displaying the remaining time. The

digital readout is displayed in hours and minutes until less than one
minute remains. Once the remaining time is less than one minute, the
digital readout counts down in seconds.

6. At the end of the timed cycle, the digital readout will flash “0.00” and an

alarm will sound until the TIME KEY is pressed.

7. Remove product from cabinet.
8. At the end of the day, or if the cabinet will not be used for an extended

period of time, press the POWER SWITCH to OFF.

Typical Time
Remaining
reading

Timed Cycle
Completed

POWER INDICATING LIGHTS FOR TOP

AND BOTTOM HEATERS (EACH CAVITY)

8

MOIST FOOD HOLDING IN
MZ CABINETS:

Use top and/

or bottom heat with pan lid in
place.

CRISPY / FRIED FOOD
HOLDING IN MZ CABI-
NETS:

Use bottom and top

heat and remove pan lid.

Advertising
This manual is related to the following products: