Bosch 4405 - Manual (Page 22)

22.
Basic Saw Operations
To Engage:
1. Lift the miter detent trigger.
2. Push the detent override clip forward and latch
in place over edge. Release miter detent trigger
(Figure 23).
3. Move miter arm to any position on the miter
scale.
4. Lock the miter lock knob to retain miter position.
To Disengage:
5. Loosen miter lock knob and lift the miter detent
trigger to release the detent override clip. The
clip should automatically disengage and the
table should lock into any desired miter detent.
Figure 23. Detent Override
1
Detent Override
So as to provide sufficient (mini-
mum 6”) spacing from hand to
saw blade, extend the sliding fences and base
extensions when making extreme bevel, miter or
compound cuts.
The base extensions can also be used to provide
extra support for long workpieces.
Adjusting the Extensions:
1. Loosen the base extension clamping levers.
2. Extend sliding base extensions to the desired
position.
3. Press the levers down to clamp the extensions
into place.
If the clamping force of the Base Extension Clamping
Levers needs to be adjusted, simply pull the red tab
outward and rotate it toward the center of the saw.
Let the red tab spring back into a new groove. When
the red tabs are rotated down to clamp the rods, they
will grip the rods with greater force.
WARNING !
Base Extensions
Base
Extension
Base Extension
Clamping lever
Figure 24: Base Extensions
Miter Lock
Knob
Miter Detent
Trigger
Table
Detent
Override Clip
Clip Edge