Carter-Hoffmann DF2620-3SS User Manual
Page 13
13
CABINET MAINTENANCE
CASTERS
Caster bearings may be equipped with Zerk grease fittings so that
they may be easily lubricated with a grease gun. Lubricate bear-
ings at least once every six months.
STACKING FOUR– AND FIVE-SHELF UNITS
This task takes about 30 minutes & requires two people.
1. Using a screwdriver, remove the screws that attach the top on
the unit that you wish to be on the bottom of the stack (unit
#1). Remove the cover and set aside.
2. Place a large piece of cardboard, moving blanket or other pro-
tective material on the floor. For the other unit (unit #2), care-
fully tip it onto one of its sides (not the front or the rear). Then,
using a wrench, remove the bolts that attach the casters to the
bottom of the unit #2. Set casters aside.
3. Tip unit #2 back to an upright position. Lift and place unit #2 so
it nests in the open top of unit #1, taking care to line up the
holes where the screws were removed.
4. Replace screws into the top edge of unit #1, securing it to the
bottom of unit #2.
5. Keep extra top and casters on hand for spare parts, or if you
should ever wish to separate the units.
WARNING:
DO NOT perform
these procedures
while the cabinet is turned on
or heated. Turn off the power
and wait for the cabinet to cool
to room temperature.