Carter-Hoffmann EPDHT Series - Manual (Page 5)

5
PLATE LOADING AND SPRING ADJUSTMENT
The tension on the self-leveling carriage is adjustable for differing
types of dinnerware, by connecting or disconnecting the tension
springs. As you are loading plates, observe the plate level. The
top of the stack should be maintained at a comfortable height. If
the level is too high or too low, springs will have to be added or
removed to attain the desired height. To ensure smooth opera-
tion, use a similar number of springs on al four sides of the tube.
This is done by connecting or disconnecting the springs from the
bottom retainer bracket.
1) Remove the open tube assembly from the cabinet. Stand the open tube upright and secure it
to prevent tipping.
2) Test the spring tension by stacking 10 pieces of dinnerware (approximately 6” high) on the
platform and note the position of the top pieces.
3) Disconnect or connect tension springs until the right combination is found to allow the top
piece of dinnerware to be raised just high enough to be easily picked from the dispenser. In
order to allow the platform to stay level and operate smoothly, be sure to make the same
changes to all four sections of the carriage springs.
4) Disconnect unused springs from the bottom retainer bracket and allow them to dangle. They
will remain out of the way, but available later adjustments, if needed.
5) Once the proper adjustment has been achieved, place the self-leveling tube back into the
cart.
Springs
Bottom Retainer Bracket
Spring Hooks
Lift entire tube out of
cabinet to adjust springs
CAUTION : If you
have a heated dis-
penser, unplug cabi-
net and allow to cool before
adjusting spring tension.