chiliGREEN M860TU - Manual (Page 82)

BIOS Utilities
5 - 8 Advanced Menu
5
Advanced Menu
Installed O/S (Advanced Menu)
This setting tells the computer what kind of operating system you’re using. Make
sure you choose the correct setting for your O/S in order to prevent system problems.
Note: If you select the Vista O/S then the SATA Mode Selection menu will become
available. If you are installing the Windows XP O/S make sure you have set the ap-
propriate operating system here in order to prevent system problems.
Figure 5 - 3
Advanced Menu

SATA Mode & eSata Port
You should select AHCI
mode in SATA Mode Se-
lection to support the e-
SATA port in Windows
Vista (hot-swapping is not
supported in Windows
XP).
Intel Turbo Memory
Select AHCI mode in Sata
Mode Selection if you
have included an Intel Tur-
bo Memory module in your
purchase configuration.
You should then enable
support for Intel Turbo
Memory from DFOROM
(Robson) Support (see
page
5 - 9 ).
Main A Advanced Security Boot Exit
F 1 Hel p Sel ec t I t em - / + Change Val ues F 9 Set up Def aul t s
E s c Ex i t Sel ec t Menu E nt e r Sel ec t Sub- Menu F 10 Save and Ex i t
I t em Spec i f i c Hel p
Advanced
Sel ec t t he oper at i ng
s y s t em i ns t al l ed
on y our s y s t em whi c h
y ou wi l l us e mos t
c ommonl y .
Not e: An i nc or r ec t
s et t i ng c an c aus e
s ome oper at i ng
s y s t ems t o di s pl ay
unex pec t ed behavi or .
Phoenix SecureCore(tm) Setup Utility
Installed O/S: [ VISTA ]
SATA Mode Selection: [AHCI]
DFOROM (Robson) Support: [Enabled]
Legacy USB Support: [Enabled]
Boot-time Diagnostic Screen: [Disabled]
Legacy OS Boot: [Enabled]
Reset Configuration Data: [No]
Power On Boot Beep [Disabled]
Battery Low Alarm Beep [Enabled]
Fan Control: [Automatic]
Only available if Windows Vista
is selected as the O/S.