4 error messages and beep codes, 1 bios error messages, 4error messages and beep codes – chiliGREEN D915GAGL User Manual

Page 99: What this chapter contains

Advertising
background image

99

4

Error Messages and Beep Codes

What This Chapter Contains

4.1

BIOS Error Messages .................................................................................................. 99

4.2

Port 80h POST Codes ............................................................................................... 101

4.3

Bus Initialization Checkpoints .................................................................................... 105

4.4

Speaker...................................................................................................................... 106

4.5

BIOS Beep Codes...................................................................................................... 106

4.1

BIOS Error Messages

Table 50 lists the error messages and provides a brief description of each.

Table 50. BIOS Error Messages

Error Message

Explanation

GA20 Error

An error occurred with Gate A20 when switching to protected
mode during the memory test.

Pri Master HDD Error
Pri Slave HDD Error

Could not read sector from corresponding drive.

Pri Master Drive - ATAPI Incompatible
Pri Slave Drive - ATAPI Incompatible

Corresponding drive in not an ATAPI device. Run Setup to make
sure device is selected correctly.

A: Drive Error

No response from diskette drive.

Cache Memory Bad

An error occurred when testing L2 cache. Cache memory may be
bad.

CMOS Battery Low

The battery may be losing power. Replace the battery soon.

CMOS Display Type Wrong

The display type is different than what has been stored in CMOS.
Check Setup to make sure type is correct.

CMOS Checksum Bad

The CMOS checksum is incorrect. CMOS memory may have
been corrupted. Run Setup to reset values.

CMOS Settings Wrong

CMOS values are not the same as the last boot. These values
have either been corrupted or the battery has failed.

CMOS Date/Time Not Set

The time and/or date values stored in CMOS are invalid. Run
Setup to set correct values.

DMA Error

Error during read/write test of DMA controller.

FDC Failure

Error occurred trying to access diskette drive controller.

HDC Failure

Error occurred trying to access hard disk controller.

Checking NVRAM.....

NVRAM is being checked to see if it is valid.

continued

Advertising