chiliGREEN K8NHA-M Grand - Manual (Page 12)

12 12 12 12 12
English English English English English
BIOSTAR Motherboard
(2) System Fan Headers: JSFAN1/JSFAN2
Pin Assignment
1
Ground
2 +12V
3 FAN RPM Sense
3. Installing DDR Module 3. Installing DDR Module 3. Installing DDR Module 3. Installing DDR Module 3. Installing DDR Module
1. Unlock a DIMM slot by
pressing the retaining clips
outward. Align a DIMM on the
slot such that the notch on the
DIMM matches the break on
the slot.
2. Insert the DIMM firmly and
vertically into the slot until the
retaining chip snap back in place
and the Dimm is properly
seated.
7. How to set up Jumpers? 7. How to set up Jumpers? 7. How to set up Jumpers? 7. How to set up Jumpers? 7. How to set up Jumpers?
The illustration shows how to set up jumpers. When the Jumper cap is placed
on pins, the jumper is “close”. IF no jumper cap is placed on the pins, the jumper is
”open”. The illustration shows a 3-pin jumper whose pin1and 2 are “close” when
jumper cap is placed on these 2 pins.
Jumper open Jumper close Pin1-2 close
8. Jumpers, Headers, Connectors & Slots: 8. Jumpers, Headers, Connectors & Slots: 8. Jumpers, Headers, Connectors & Slots: 8. Jumpers, Headers, Connectors & Slots: 8. Jumpers, Headers, Connectors & Slots:
(1) Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector
supports the provided floppy drive ribbon cables.
1