chiliGREEN Media Recorder 3 Firmware Update - Manual (Page 4)

4 Chiligreen MR3 Firmware Update - English
I can not see any picture on the TV-System while updating the Firmware
Please check if the MR3 is connected via AV-OUT on the TV-System, and if the TV-System is
configuried on the correctly channel. If the LEDs on the front side of the MR3 are flashing, do not
disconnected or power off the MR3.
The firmwareupdate now runs for 15 minutes and more.
Disconnect the MR3 from the Power Supply Unit. Open the case on the bottom side, and
disconnected the hard disk drive. Start the Firmware Update again. After firmware Update please
install the hard disk drive into the case.