COATS Fixed Finger Plates - Manual

Instructions
1. Using a hole gauge, position the hole gauge
probes firmly into consecutive wheel lug holes and
tighten the lock screw.
2. Remove the hole gauge and read the scale that
matches up with the number of lug holes as the wheel.
The measuring surface of the hole gauge lines up with
the scale mark that indicates the bolt circle pattern. Find
the fixed finger plate with the indicated bolt circle pat-
tern (see page 2)
3. Select the cone that best fits the center hole in the
wheel. Slide the back cone spring and the cone onto
the balancer shaft.
4. Lift the wheel onto the shaft and center it on the cone.
5. Next, align the fixed finger plate’s fingers with the
wheel lug holes.
6. Install the hub nut onto the shaft. Tighten securely.
Follow wheel balancer manufacturer’s recommended
procedure for balancing tires.
Fixed Finger Plates
Mounting Wheels Using Fixed Finger Plates
8113016 06 03/11 1 of 2
Number of
Lug Holes
Bolt Circle
Pattern
Scale Marks
Measuring
Surface
Scales