COATS Kit 8113223 (1.125-inch), Kit 8113228 (40 mm), VW/Porsche Adapter User Manual
Vw/porsche adapter, Balancing solutions, For use with coats wheel balancers
8113222 00 7/01
© COPYRIGHT 2001 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.Hennessy-Ind.com
1.125 inch Kit 8113223
40 mm Kit 8113228
For use with COATS Wheel Balancers
Instructions
1. Fasten the tire assembly to the adapter using the existing vehi-
cle studs, figure 1.
2. Mount the adapter/wheel assembly on the balancer shaft and
fasten it to the faceplate using a hubnut with pressure cup, figure 2.
3. Zero balance following standard balancing procedures.
4. Remove adapter/wheel assembly from balancer, unfasten
adapter from the wheel, and then remount the tire assembly to the
vehicle.
Shaft/Faceplate
Studs from
Vehicle
Hub Nut with
Pressure Cup
®
Balancing Solutions
VW/Porsche Adapter
VW/Porsche
Adapter
Figure 1
Figure 2