COATS Kit 8113860 Splash Guard - Manual

8113859 01 05/07 © COPYRIGHT 2004 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
Splash Guard Kit 8113860
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Assembly Instructions
1. Install the plastic motor shield (part #8113855)
over the front of the motor. Use the hose clamp (part
#8113854) to secure the motor shield in position. See
figure 1.
Figure 1
2. Apply the aluminum duct tape over the encoder
board opening at the back of the motor. See figure 2.
3. Remove the (4) screws from the capacitor bracket
and rotate the bracket so that the electrical connec-
tions on the capacitors are pointing downward. See fig-
ure 2.
Figure 2
4. Re-attach the bracket to the balancer cabinet using
the (4) screws.
5. Install the power panel shield part #8113857 over
the (2) 1/4-inch screws protruding through the balancer
cabinet. Secure in place with the (2) 1/4-inch hex nuts
part #8143169. See figure 3.
Figure 3
6. Remove the (3) screws securing the power panel
to the cabinet (fig. 3) and install the formed vinyl switch
and circuit breaker cover through the holes in the cabi-
net (fig. 4). The switch and circuit breaker cover will be
held in place once the power panel has been re-
installed.
Figure 4
7. Remove the touch panel assembly from its hous-
ing and place the formed PCB shield part #8113858
over the back of the touch panel assembly. Route the
electrical wires through the slotted openings. Re-install
the touch panel assembly in its housing. See figure 5.
Figure 5
Hose Clamp
Motor
Shield
Capacitor
Bracket
PCB Shield
Aluminum
Duct Tape
Vinyl Cover
Power Panel Power
Panel
Shield