COATS Kit 8113932 16 Bit PCB & Metal Arm User Manual
Instructions
8113933 02 4/05
© COPYRIGHT 2004 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
16 Bit PCB & Metal Arm Kit #8113932
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Instructions
1. Replace the PCB. Repack the old PCB and return it
to Hennessy Industries.
2. Remove the Plastic Diameter Arm from the dis-
tance rod.
3. Place the large black fender washer (in Kit) under
the existing 6mm screw. Then attach the Metal
Diameter Arm, supplied in the Kit, to the distance rod.
4. Important: It is necessary to perform a NOVRAM
reset on startup.
5. Power up machine and check for function of all
operations. Make any necessary adjustments:
• Ensure that Distance and Diameter Pots are set
between 2500 & 3500 on Machine Self-Test (Green
Screen).
• If Arm Calibrations are required:
Press the
key and select the SERVICE
ADJUSTMENTS option
. At the PASSWORD
prompt enter 1-3-5-7.
Toggle the DISTANCE/DIAMETER ARM TYPE
option to
METAL.
In the following order, select the DISTANCE ARM
CALIBRATION option
, WIDTH SONAR CALI-
BRATION option
, and DIAMETER ARM CALI-
BRATION option
, following the on-screen
instructions for each calibration. Note: At the end of
the Diameter Arm Calibration, hold the NEXT but-
ton down until 281 degrees flashes on-screen; then
return the arm to its home position.
Important: Once the Arm is calibrated, there is lit-
tle need to calibrate it again.
6. To Calibrate with the 4-ounce weight, press the
key, then select SPECIAL FUNCTIONS option
and choose MACHINE SELF-CALIBRATION selec-
tion
. Follow the instructions on-screen.
Important: The dimensions entered must match the
“calibration wheel”. A dimension cannot be zero.
7. If not already done, you may want to enter the
Owner Name and Address for the screen saver. The
OWNER ADDRESS selection is found under the SPE-
CIAL FUNCTIONS menu.
8. The Board is factory set with the following menu
settings:
General Set-up
Runout Unloaded
" = SONAR (radial)
Balancing Set-up
Runout Diagnostic = ON
Runout Limits
Max. True Limit = .050"
Rim Runout Limit = .010"
Correction Runout Limit = .030"
Special Functions
Static Unbalance Displayed = ON
Stop On Top = OFF
6
7
MENU
3
2
1
5
4
MENU