COATS Kit 814422 Hood Stop Retro User Manual
COATS Equipment
8114423 00 11/05
© COPYRIGHT 2005 ALL RIGHTS RESERVED PRINTED IN U.S.A.
Instructions:
1. Hold bracket up to the edge of the hood cam
plate and mark the two holes on the plate to drill.
2. Use a punch to mark the center of the holes.
3. Drill out two holes using a 5/16-inch bit. Note
that it may be easier to first drill out a small pilot
hole.
4. Install bracket with the supplied button head
screws and nuts.
5. Ensure proper activation of hood after installa-
tion by lowering the hood to make sure the mecha-
nism activates the tire rotation.
6. If the rubber stop is completely worn out,
replace rubber stop with the one supplied in the kit.
H
Ho
oo
od
d S
Stto
op
p R
Re
ettrro
o
K
Kiitt 8
81
11
14
44
42
22
2
ffo
orr X
XR
R S
Se
erriie
es
s W
Wh
he
ee
ell B
Ba
alla
an
nc
ce
errs
s
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com