COATS Kit 85009084 Monitor Replacement - Manual

85009140 00 03/08 © COPYRIGHT 2008 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
XR Series (1750, 1800, 1850)
Balancer LCD Monitor Replacement
Kit 85009084
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Disassembly Instructions
1. Turn off power to balancer and unplug from power
source. On an 1800 or 1850 model, disconnect the air
supply.
2. Unplug monitor video cable and the power cable
from back of monitor (do not disconnect from PCB
boards).
3. Remove monitor from balancer.
4. Unplug touch panel ribbon cable.
5. Remove touch panel and hardware (be careful not
to damage). Save these items for installation on new
LCD monitor kit 85009084.
6. Remove front tower cover by removing bottom
two 1/4-inch hex head screws and loosening upper two
1/4-inch hex head screws. On an 1800 or 1850 model,
disconnect the two air hoses coming up from the tower
and save for new installation.
7. Remove 1/2-inch flat head socket cap screw,
washer and nut holding monitor tray to tilt bracket.
8. Remove grip strip, monitor plate and monitor tray.
Leave the three rub buttons assembled in tilt tower
bracket.
Assembly Instructions
1. Assemble touch panel (removed from old monitor
assembly) to front of keypad bracket using saved hard-
ware.
2. Assemble new LCD monitor assembly to tilt tower
bracket using new 1/2 x 1 1/2-inch hex head cap screw,
washer and nut supplied in kit. Tighten until LCD mon-
itor assembly is slightly difficult to rotate.
Note: Make sure the three rub buttons are still
installed in tilt tower bracket before attaching LCD mon-
itor assembly.
3. Next, feed monitor video cable, monitor power
cable and ribbon cable up through slot and hole in mon-
itor mounting tube. Be careful not to damage cables.
4. Connect monitor video cable and monitor power
cable to LCD monitor.
5. Connect ribbon cable to touch panel.
6. On an 1800 or 1850 model, remove parts from
front tower cover and reassemble in new front tower
cover (be sure parts are assembled exactly as removed
from old cover). On a 1750 model, use the cover sup-
plied as is with no changes.
7. Assemble front tower cover to monitor tower.
Note: On an 1800 or 1850 model, reattach the two air
hoses to the front tower cover first before assembly to
the monitor tower.
8. Connect to power supply. On an 1800 or 1850
model, connect the air supply.
9. Power up machine. Turn on the LCD monitor and
adjust the LCD screen as required. Check for air leaks
on an 1800 or 1850 model.
Monitor
Video Cable Monitor
Power Cable
Slot for Cables
Channel
for Cables
Monitor Tray
Touch Panel
Grip Strip
Monitor Plate
Tilt Bracket Rub Button
LCD
Monitor
Hex Head
Cap Screw
Ribbon Cable
Tilt Bracket
Washer
Nut
Touch Panel
Video Cable
Monitor
Power Cable