COATS Wheel Balancer Hood - Manual

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
85609424 01 05/14 © COPYRIGHT 2014 ALL RIGHTS RESERVED PRINTED IN U.S.A.
Washer
Retainer
Washer
Plastic
Protector
Hood Bar
Hood Cam
Stud
Nyliner Bearing
Nyliner Bearing
Hood Installation Instructions
1. On Vero models, apply supplied grease to inside
and outside of nyliner bearings. Install nylon bearings
in the ends of the hood pivot tube.
2. Insert hood tube thru the hood pivot bearings.
3. Install flat washer and retainer washer on the end
of the hood bar making certain that the retainer washer
is fully seated.
4. Install plastic protector over the end of the hood
tube.
5. Hook hood spring on bottom of cabinet adjacent to
the rear chassis leg in the provided notch in the chas-
sis. Hold hood in upright position and install spring on
to the hood cam stud.
Note: The caliper hook can be attached to the unit by
utilizing one of the weight tray hex head screws.
Hood Installation
Instructions