COATS 1001 & 1001SC Balancer - Manual (Page 20)

Wheel Mounting Options
Back Cone Mounting
1. Place spring over threaded stud with the large end
inside of the faceplate.
2. Select a cone that best fits into wheel center hole.
3. Slide selected cone onto threaded shaft with the
large end against the spring.
4. Lift wheel onto shaft and center on cone.
Cone centers wheel—Cone must be cen-
tered in wheel center hole before tightening.
The wheel must be forced firmly against the
faceplate. Thread hubnut on and tighten by
rotating wheel and striking both arms of
hubnut with palm of hand. Hubnut must
engage threads for at least four full turns.
Failure to tighten hubnut securely may result
in serious personal injury.
Light Truck Cone
Cone must be centered in wheel center hole
before tightening. Thread hubnut on and
tighten by rotating wheel and striking both
arms of hubnut with palm of hand.
Hubnut must engage threads for at least
four full turns. Reverse hubnut when neces-
sary. Hubnut and cone must force wheel
firmly against faceplate. Failure to tighten
hubnut securely may result in serious per-
sonal injury.
CAUTION
CAUTION
CAUTION
CAUTION
Direct Drive
14 • COATS 1001 Wheel Balancer