COATS 6450 3D - Manual (Page 11)

Important: Always read and follow the information box instructions. • 5
Figure 7C - T2-Tape (Hidden Tape-A-Weight®) Data Entry
Diagram
Using The Laser Locator
If the T2 - Tape (hidden Tape-A-Weight®) location is
selected, use the laser locator to point to the hidden
weight location (figures 8 & 7B). Rotate laser locator
knob to position the laser dot outboard at the desired
T2-Tape (hidden Tape-A-Weight®) location.
Note: For best performance, choose a weight position
outboard as far inward (in the rim) as wheel allows.
Figure 8 - Positioning Laser Dot At T2 - Tape Hidden Weight
Location (A2)
Note: The T2 - Tape Direct Select™ Weight position
is the only mode that requires the A2 & D2 dimension
measurements.
Using The Line Laser
If the T2 - Tape (hidden Tape-A-Weight®) location
is selected, use the line laser to align the offset arm
with the laser locator dot (figures 8 & 7B); entering
A2 & D2 measurements automatically. Grasp arm at
the line laser and pull out and up to the wheel flange
(figure 6B). Hold arm still at the clip-on weight location
and wait for BEEP. Then, before returning arm to home
position, press button on line laser to activate the line
laser beam. Move arm to inner area of wheel and align
line laser beam with laser locator dot (figure 8). Hold
arm still, up against the rim, in the same plane as the
T2-Tape (hidden Tape-A-Weight®) location (figure 7A &
7B) and wait for BEEP. Refer to figure 9.
Note: The line laser remains on for ten seconds after
its button is pushed.
Figure 9 - Positioning Line Laser Beam At T2 - Tape Hidden
Weight Location (A2)
3D - Using the Hood Sonar
When prompted by the balancer instructions, use the
hood sonar - width sensor (figure 10) to enter wheel
width measurement automatically. Lower balancer
hood guard to enter the measurement.
Figure 10 - Tire Width Sonar Located Inside Hood
Note: Refer to page 7 to measure the W dimension
manually using the plastic calipers (2D & 3D models).
Laser
Locator
Dot
Laser
Locator
Knob
Center Line
Laser Beam
on Laser
Locator Dot
Press Line
Laser Button