COATS CDH-9043 Electric-Hydraulic Tire Changer - Manual (Page 3)


Pump motor
Gear-box motor
Handles rim from
Max. wheel diameter
Max. wheel width
Max. wheel weight
Weight (with standard accessories)
Acoustic pressure level (at work)
GENERAL INFORMATION 1
This tyre changer has been specifically designed to demount and mount truck, bus and commercial van tires, with rims from 14" to 56"
and a maximum 90” (2.300) mm diameter.
Any other use is improper and therefore not authorized. Before beginning any kind of work on or with this machine, carefully read and
understand the contents of these operating instructions.
The Manufacturer shall not liable for any injury to persons or damage to things caused by improper use of this machine.
KEEP THIS MANUAL NEAR THE MACHINE AND CONSULT IT AS NEEDED DURING OPERATIONS.
Any work, however minor, on the electric system must be done exclusively by professionally qualified personnel.
2 TECHNICAL DATA
3 GENERAL SAFETY REGULATIONS
The use of this machine is reserved to specially trained and authorized personnel.
Any unauthorized changes or modifications to the machine, in particular to its electric system, relieve the manifacturer from all liability.
Removing or tampering with the safety devices installed on this machine is in violation of European Safety Regulations.
4 SAFETY DEVICES
The tire changer has a number of safety devices designed to guarantee the utmost operator safety:
1. Check valve on the spindle opening hydraulic line (inside the swivel connector, see fig. B/1). This prevents the wheel from falling from
the spindle if the hydraulic line is accidentally broken.
2. Pressure relief valve factory set at 1,885 PSI (130 bar) ±10% (See Fig. B/2).
This limits the pressure in the hydraulic circuit and ensure correct operation of the plant.
3. Pump motor overload cut-out (inside the electric enclosure).
This cuts in if the motor overheats to prevent it from burning out.
4. Check valve on the chuck arm lifting hydraulic line. It prevents the chuck arm from descending when any accidental break occurs
in the hydraulic circuit.
1.1 kw
1.3 / 1.8 kw
14" - 56"
2,300 mm
1,065 mm
1,500 kg
770 Kg
LpA <70 dB (A)
Electric Power requirement 220V - 3 PH - 60Hz 15 Amp