COATS HIT 5000 Truck Tire Changer - Manual (Page 6)

vi • COATS H.I.T. 5000 Changer
H.I.T. 5000
Installation
It is not necessary to bolt the H.I.T. 5000 to the floor.
However, if desired, use the holes provided in the
base of the machine.
Most electrical codes require machinery
that is permanently installed to be wired
directly to the power source via conduit.
Remove the H.I.T. 5000 from the shipping pallet and
position on a relatively level and smooth floor, prefer-
ably concrete.
Important: Read this operators manual thoroughly
before attempting to change any tires. Also, actuate
the controls several times to become familiar with
their function and direction.
Electrical Installation
The H.I.T. 5000 requires 220 volts, 60 cycle, single
phase power, with a 20 amp circuit. An optional model
is available for 110 volt, single phase.
Important: Have a licensed electrician connect the
H.I.T. 5000 to the power source. The licensed electri-
cian must sign the warranty registration card to vali-
date the warranty.
CAUTION