COATS HIT 9000, Truck Tire Changer - Manual (Page 6)

vi • COATS H.I.T. 9000 Changer
H.I.T. 9000
Installation
It is not necessary to bolt the H.I.T. 9000 to the floor.
However, if desired, use the holes provided in the
base of the machine.
Most electrical codes require machinery
that is permanently installed to be wired
directly to the power source via conduit.
Remove the H.I.T. 9000 from the shipping pallet and
position on a relatively level and smooth floor, prefer-
ably concrete.
Important: Read this operators manual thoroughly
before attempting to change any tires. Also, actuate
the controls several times to become familiar with
their function and direction.
Electrical Installation
The H.I.T. 9000 requires 220 volts, 60 cycle, single
phase power, with a 20 amp circuit. An optional model
is available for 110 volt, single phase or 220 volt, 3
phase power.
Important: Have a licensed electrician connect the
H.I.T. 9000 to the power source. The licensed electri-
cian must sign the warranty registration card to vali-
date the warranty.
CAUTION