COATS Kit 8183061, Duckhead Mount/Demount Tool Upgrade - Manual

8183063 04 06/09 © COPYRIGHT 1995 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
Duckhead™ Mount/Demount Tool
Upgrade Kit 8183061
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX
Note: These instructions are to be used
on tapered vertical slide shafts only.
Nylon mount/demount tools are not cov-
ered under regular warranty as these items
are expendable.
Mount/Demont Tool Head Adjustment
To Adjust Tool Head Lift
Shoulder screw (ref.1) sets the tool head lift for
metal duckheads – no adjustment required. Place
shim 85606345 on screw if using a plastic duck-
head.
To Adjust Lock Tightness
With lock handle unlocked, loosen jam nut (ref. 2)
and adjust pin (ref. 3) until a slight firmness is
obtained, then tighten jam nut and check. Also
recheck tool head lift at this time.