COATS Kit 8183846, Mount/Demount User Manual
For rim clamp tire changers
8183847 03 06/09
© COPYRIGHT 2000 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
Mount/Demount Kit #8183846
for Rim Clamp Tire Changers
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX
Note: There should be about 12-degrees of rota-
tional play of the plastic mount/demount head when
installed to allow the tool to self align when in use.
Item
Part No.
Description
1
8106302
3/8-16 Whiz Lock Screw
2
8182027
7 ga. x .406 x 1.28 OD Washer
3
8182960
Plastic Mount/Demount Head
4
85606345
Shim
These parts not supplied with kit, shown for ref-
erence only.
Mount/Demont Tool Head Adjustment
To Adjust Tool Head Lift
Shoulder screw (ref.1) sets the tool head lift for
metal duckheads – no adjustment required. Place
shim 85606345 on screw if using a plastic duck-
head.
To Adjust Lock Tightness
With lock handle unlocked, loosen jam nut (ref. 2)
and adjust pin (ref. 3) until a slight firmness is
obtained, then tighten jam nut and check. Also
recheck tool head lift at this time.