COATS Kit 8184045, Robo Arm - Manual (Page 2)

5. Next, install the large plated spacer, the swing
arm (note position of the decal) with pivot pin spacer,
and the lock nut. Next, using large wrenches, tighten
the assembly to 240 ft. pounds torque (very tight).
Even though the bolt is very tight, the assembly
should rotate easy.
6. Next, locate arm with cylinder, install seven inch
bolt with head through the bottom side, slide pivot
pin over bolt and attach nut with only one turn.
7. Slide the cylinder arm through the swing arm
bushing, hold in position, remove nut and place
washer over bolt threads and assemble nut to bolt.
8. Next using large wrenches, tighten the assem-
bly to 240 ft. pound torque (very tight). Again, even
though the bolt is very tight, the assembly should be
free to rotate.
Robo-Arm™
2 • Robo-Arm™ Kit Installation
Figure 5
Figure 6
Figure 7
Figure 8
Spacer
Nut
Bolt
Pivot Pin
Large Washer
Decal