COATS Kit 85606545, Kit 85606739 Bead Sealer Accessory - Manual (Page 2)

2 • COATS
CAUTION
Always DISCONNECT THE ELECTRICAL
POWER before servicing equipment. This
prevents electrical shock or accidental
movement of the systems operated by the
electrical power.
CAUTION
Always DISCONNECT AIR SUPPLY before
servicing equipment. This prevents acciden-
tal movement of systems operated by com-
pressed air which may result in personal
injury. BLEED THE AIR SYSTEM by actuating
all the valves.
CAUTION
Always wear safety goggles to protect your
eyes.
Installation for Rim Clamp® Tire Changers
1. Disconnect tire changer from power source and
from its air supply. Bleed off all air pressure. Verify the
stored air pressure is zero by observing the air pressure
gauge.
2. Remove the tee gauge assembly (A) from top of
air receiver.
3. Install the fitting assembly (B) into top of air
receiver. Be sure to use pipe sealant on pipe threads
to prevent leakage.
4. Reinstall the gauge assembly (A) into fitting
assembly (B) top.
5. Attach hose (C) to bead sealer accessory assem-
bly (B).
6. Next, reconnect the air pressure source and check
for air leakage at fittings.
7. Using the 6-inch hose clamp, secure the hanger
to the tower.
A
B
C