COATS Kit 85607471 Leverless Bead Lifter - Manual (Page 7)

Important: Always read and follow the operating instructions. • 7
9. Now repeat step 5, to position tool for lower bead
removal (figure 5).
Figure 5 - Bead Lifter Tool Hooked Under Tire Bead
10. While holding tire up in the drop center, lift tire
to hook the bead on leverless tool, push control handle
up to lift bead over rim (figure 6).
Figure 6 - Push Control Handle Up To Lift Bead Over Rim
11. Depress the table top pedal to rotate wheel. The
bead lifter tool will guide the bead up and over the edge
of the wheel. Continue rotation until the lower bead is
demounted.
Tire Mounting
12. Lubricate tire beads liberally with tire manufac-
turer’s approved rubber lubricate.
13. Place tire over wheel and move swing arm into
position making sure the valve stem is at the 9 o’clock
position in front of bead lock. Position tire so that lower
bead is above the rear extension of the bead lifter tool
and below the front knob (figure 7).
Figure 7 - Position Tire Against Bead Lifter Tool
14. Depress table top pedal and rotate wheel to
mount lower bead. Use drop center of wheel by forc-
ing down on tire just ahead of the mounting tool, and
follow as tire rotates Rotate table top until lower bead
is mounted.
15. For top bead installation, rotate table top until
the valve stem on wheel is just in front of where the
bead crosses the rim (figure 8). Be sure the tire is on
top of the mount/demount head tail.
Figure 8 - Position Valve Stem In Front Of Bead Lock
16. Slightly lower leverless tool to push bead down;
hold opposite side of tire down into drop-center.
17. Depress table top pedal and rotate tire until
bead is mounted. Be careful to ensure bead stays in
the rim drop center in the area ahead of the bead lifter
tool.
18. Inflate, unclamp per standard instructions.
Valve
Stem
Valve
Stem