COATS Supplemental PAX - Manual

• Position riser on table top.
• Place large roller on tire at rim
edge, apply pressure and loosen
bead.
• Rotate tire; lubricate between tire
bead and rim.
• Insert end of plastic protector into
gap between tire and rim.
Note: Be sure slot for lifting tool is
toward rubber; not the rim.
• Rotate in reverse, allowing protec-
tor to insert fully.
• Using both hands, insert lift tool
between protector and tire.
• Slowly rotate lift tool toward cen-
ter of rim; tire bead should slide
over top rim flange.
Demounting Tire With Support
Supplemental PAX Instruction
• Place tapered roller at lower rim
edge, apply pressure creating gap.
• Rotate tire and lubricate between
tire bead and rim.
• Continue to rotate and apply
upward force until the entire
lower tire bead is in the small drop
center area of the rim.
• Allow roller to contact inside edge
of support system.
• Apply pressure to dislodge clips;
push tire/support off rim.
• Rotate table top scallop facing lift.
• Place zee bracket on lift.
• Raise lift and wedge tire between
zee bracket and table top. • Use Robo Arm and nylon web
sling; wrap sling around support.
• Insert lift tool between support
and tire; to guide support out of
tire as upward force is applied to
the nylon web sling.
• Completely remove the support
from the tire.
Remove Support From Tire
85000617 00