COATS Pit Tire Changer - Manual (Page 15)

Important: Always read and follow the operating instructions. • 11
4. Release air pressure from tire by raising up on the
inflation pedal (inflation hose must be attached to the
valve stem. Never add or adjust tire pressure using an
air hose without a clip-on air chuck and in-line valve. Do
not use a hand-held style chuck (figure 1).
5. Important: When inflating tires that require more
than 60 PSI, always use a safety cage and air hose with
a clip-on air chuck and in-line valve. The air hose must
have enough length between the chuck and the opera-
tion/in-line valve to allow the operator to stand outside
the trajectory.
Note: If you change tires defined as truck tires, they
must be inflated per OSHA instructions.
Figure 1 - Do Not Use a Hand-held Style Air Chuck
Maintenance
Instructions
Read and follow all the maintenance instructions pro-
vided in this manual to keep the machine in good oper-
ating condition. Refer to the other materials received
with the unit and to the service bulletins from the man-
ufacturer for additional instructions on proper mainte-
nance and service. Regular inspections and proper
maintenance are essential to preventing accidents and
injuries.
Before making any inspection, adjustment,
or repair, disconnect all power sources and
block out all moving parts to prevent injury.
Keep the machine and the immediate work
area clean. Do not use compressed air to
remove dirt and debris from the machine.
Foreign material may be propelled into the
air and into operator or bystander causing
personal injury.
Wear protective clothing, equipment and
eye protection when making any adjust-
ments or repairs to the machine.
A. Check the adjustment of the Duckhead once a
month.
B. The transmission in this machine is a sealed unit
packed with grease and should need no normal main-
tenance.
C. Check the tire pressure gauge function daily, and
check the accuracy monthly. Use a pressurized tire and
a high quality stick-type pressure gauge. If necessary,
adjust the dial of the machine gauge. If the gauge is
defective, replace it immediately. Contact COATS at
(615) 641-7533.
D. Make sure all fasteners are securely tightened.
E. Make certain that all guards and covers are in
place.
F. Check for worn, damaged or missing parts includ-
ing grips and protective covers. Replace them before
allowing the unit to be used.
WARNING
WARNING
WARNING