COATS RC-50M Rim Clamp Tire Changer - Manual (Page 9)

Figure 13 - Demounting Lower Bead
15. Turn the table top to rotate the wheel. The
demount head will guide the bead up and over the
edge of the wheel. Continue rotation until lower bead
is demounted.
Note: With tube-type tires, demount the upper bead
and remove the tube before demounting the lower
bead.
Note: Normal table top rotation for demounting is
clockwise.
At times during the mounting and
demounting procedure, the bead lifting tool
may encounter resistance or come under
load. Keep one hand firmly on the tool to
avoid possible tool disconnect. Turn the
table top counterclockwise to back out of
jam ups.
After successfully completing the demount
process, proceed to MOUNTING.
CAUTION
Important: Always read and follow the operating instructions. • 5
Motorcycle ATV
Operator Protective Equipment
Always wear durable work clothing during tire serv-
ice activity. Shop aprons or shop coats may also be
worn, however, loose fitting clothing should be
avoided. Tight fitting leather gloves are recom-
mended to protect the operator’s hands when han-
dling worn tires and wheels. Sturdy leather work
shoes with steel toes and oil resistant soles should
be used by tire service personnel to help prevent
injury in typical shop activities. Eye protection is
essential during tire service activity. Safety glasses
with side shields, goggles, or face shields are accept-
able. Back belts provide support during lifting activi-
ties and are also helpful in providing operator
protection.
✓