Comark N5001 Auditor Software - Manual

Page 1
Part No. 17931/4
Auditor Software
Quick Reference Guide
This quick reference guide will enable you to install and use the Auditor Software, supplied on the CD
ROM.
1. Installing the software
The software is designed to auto-install. Insert the CD into the CDROM drive of your computer and the
on-screen instructions should appear. Please follow these to install the software. If the software does not
automatically install, select and run the Setup.exe file from the CD.
2. Knowing your COM port number
Fig 1 Fig 2
To find your COM port, start by selecting Start-Settings-Control Panel. Then select System to bring up
the System Properties screen, See Fig 1 above. Now select Hardware then Device Manager.
From the list, see Fig 2 above right, select Ports (COM & LPT) to show the full list of COM ports.
At this time you will see the list of available COM ports on the PC.
Usually COM port 1 and 2 are available.
These are the small 9 way D shaped plugs on the back of the PC.
If you are using a USB to serial port adaptor make sure it is plugged in or else it will not show in the list.
This may be COM port 5, 6 or 7.
Make a note of the COM port you are going to use for the Auditor software and continue to 3. Running
the software for the 1
st
time.