Comark RF500A User Manual
Page 19
18
3.
Start the RF500A-CONFIG Utility using the Windows Start
Menu – The screen as shown in “Figure 3 - RF500A-CONFIG
Screenshot” opposite, will be displayed:
4.
Enter the Serial Number of the Gateway connected
then click the
View Current Settings
button - Wait until
the various fields are populated.
5.
Enter the IP address, subnet mask and Default Gateway
using dotted decimal notation into their respective fields.
Software Issue
For Comark Instruments use only
Comms Port
For Comark Instruments use only
Mac Address
Hardware address of the Ethernet interface
IP Address
The IP address allocated to the Gateway
Net mask
The subnet mask associated with the
IP
address
Default Gateway
The IP address of the network gateway to
allow access from a different subnet
6.
Click the
Save New Settings button
- After successful transfer, RF500A-CONFIG will Reset the RF500A.
The
Generate Report File
button is only for use under instruction from Comark Technical Support.
Figure 3 - RF500A-CONFIG Screenshot