Comelit MT HDDVR160A User Manual
Page 7
7
Button
Function
Power Button
Switch off—to stop DVR. Use it before turning off the power
Record Button
To record manually
-/-- /0-9 Digital Button
Input number or choose camera
Fn1 Button
Unavailable temporarily
Multi Button
To choose multi screen display mode
Next Button
To switch the live image
SEQ
To enter into auto dwell mode
Audio
To enable audio output in live mode
Switch
To switch the output between BNC and VGA
Direction button
To move cursor in setup or pan/title PTZ
Enter Button
To confirm the choice or setup
Menu Button
To enter into menu
Exit Button
To exit the current interface
Focus/IRIS/Zoom/PTZ To control PTZ camera. Move camera/zoom/IRIS/Focus
Preset Button
To enter into preset setting in PTZ mode
Cruise Button
To enter into cruise setting in PTZ mode
Track Button
To enter into track setting in PTZ mode
Wiper Button
To enable wiper function in PTZ mode
Light Button
To enable light function in PTZ mode
Clear Button
To return to the previous interface
Fn2 Button
Unavailable temporarily
Info Button
Get information about DVR like firmware version, HDD information
To
control
playback.
Play/Pause/Stop/Previous
Section/Next
Section/Rewind/Fast Forward
Snap Button
To take snapshots manually
Search Button
To enter into search mode
Cut Button
To set the start/end time for backup in playback mode
Backup Button
To enter into backup mode
Zoom Button
To zoom in the images
PIP Button
To enter into picture in picture setting mode
1.5 Control with Mouse
1.5.1 Connect Mouse
It supports USB mouse through the port on the rear panel, please refer to Fig 2.11 Remote Controller.
Notice: If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse is connected to the USB mouse port not the USB port
2. try another mouse
1.5.2 System operation by mouse
The structure of the main menu is shown in Fig 2.11 Remote Controller.
In live:
Double-click left button on one camera to be full screen display. Double-click again to return to the previous
screen display.
Click right button to show the control bar at the bottom of the screen as Fig 2.11 Remote Controller. Here are all
control and setup. Click right mouse again to hide the control bar.
In setup:
Click left button to enter. Click right button to cancel setup, or return to the previous.
If want to input the value, move cursor to the blank and click. An input window will appear as Fig2.12. It
supports digitals, letters and symbols input.
Fig 2.12 Digital Numbers and Letters Input Window